![]() ![]() Instead, to find Edge Drivers and other current code, see the new Edge Drivers page. As of December 2022, you are no longer allowed to add new groovy DTHs or Smartapps to your account, so everything found from this page is only for research purposes. Then exclude and re-add your lock.Everything on this page was written for the old groovy platform, which is scheduled to be shut down in the first quarter of 2023. Your Kwikset is supported by the Z-Wave Lock PH - Devices & Integrations / Community Created Device Types - SmartThings Community from Subscribe to his channel and install his driver. I am at a loss, can anyone point me where to look for any of the 3 issues. Everything worked perfect prior under the groovy system and the issues only showed up once the move to edge drivers occured. In the case of all three issues i have reset, removed, changed drivers even to random other drivers and back and nothing seems to solve or repair the issues. I also have a Zen17 on this second hub and the relays work just fine without any issues. All of this is on a V3 hub and as weird as the Zen16 issue is, i have a second SmartThings hub attached to my account at a different location (the wifi hub) and it does the same thing. So basically with the MimoLite for my garage and the Zen16 for my sprinklers i cannot use the status indicators in SmartThings to reliably tell me the correct status or even interact with the devices correctly and has become useless because of this. The main or parent status button operates as it should turning on and off when it is supposed to. I will have to hit it a second time to change the status to off. The first time i hit the button it turns the valve off and reports the status as off and within 2 seconds it changes the status of the relay to on again. The same issue will happen when turning it off. When i hit the button the second time it changes the status to on and stays on. When operating any of the 3 relays in the app i hit the button it will activate the valve and show a status of ‘on’ but within 2 seconds it changes the status back to off. My third issue and the one device i use a ton of routines, or at least used to was for was my Zooz Zen16 for sprinklers. I have not figured out any pattern to this as of now. As well there are times i can be out in the garage with the garage door open and after a significant amount of time it randomly decides to turn the status to closed. So this work around works great using other devices but i cannot change the way the button works in the app. To get it to close properly i choose the “open” action in order to close the door. When i try to create routines to control the garage door from another device, i can only get the control actions Open and Closed (not Close). If i refresh the status when the door shows closed when i hit the button only once and the door is actually open, it correctly changes the status back to open and i will have to hit the button twice to actually close the door. It opens the door and reports the staus correctly but for some reason the button in the SmartThings app does not close the garage door it changes the status of the door to closed and once that is done i have to hit the button a second time to send the “open” signal (since it is a momentary switch action) and then the door will close and report the proper state of the door at that time. The second issue i have is with my Fortrezz MimoLite that i used for a garage door opener. This is the model i have and looking at the fingerprints.yml the manufacture code etc is not in the yml file at all despite it being almost the same as the other KwikSet 914 locks. Factory reset the device and I have even removed all the old device handlers a while back as well. The first issue and the most minor one of the 3 was that i found my Weiser or KwickSet 914 door lock will not install an edge driver of any kind. Everything worked perfectly prior to any edge drivers being installed on my hubs. I am at a loss and cannot find a way to get things to work properly. I have 3 ongoing issues ever since the end of Groovy. ![]()
0 Comments
Leave a Reply. |